TOA Electronics F-2322C2, F-2352C2 5

Step 5. Make speaker cable connection.

5-1. Plug the wired removable input connector into the speaker's wiring socket.

5-2. Fix the speaker cable with the cord clamp.

Speaker unit

Removable input

connector

Cord clamp

Speaker cable

Clamp fixing screw (2 pieces)

Loosen the cord clamp fixing screws and open the cord clamp.

Then, pass the speaker cable between both screws.

Tighten the clamp fixing screws to

fix the speaker cable with the cord clamp.

Confirm the connector will not pull out.

Pull on the cable here to confirm that

speaker cable is securely fixed. Removable input connector

5-1

Step 6. Mount the speaker.

Caution

Before mounting, check to be sure that the speaker's

3 mounting tabs are turned inside the unit as shown in the figure.

If turned outward, the speaker cannot be inserted through the

mounting hole.

Out

Mounting

tab

6-1. Ceiling mounting (in the case of Step 2-1)

Insert the speaker through the mounting hole till it contacts

the ceiling panel. While doing so, avoid directly touching

the speaker element and diffuser section (F-2352C2 only).

Never grab the F-2352C2's diffuser

section as a hand hold. The

speaker could fall due to damage,

resulting in possible personal injury.

Rotate and tighten the mounting tab axis

screws (3 places) on the unit clockwise to their

full stop in order to grip the ceiling panel with

the mounting tabs.

Diffuser section

Speaker unit

Mounting hole

Mounting tab axis screw

Mounting tab

Use an electric screwdriver to tighten.

(Tightening torque: 6 – 10 kgf·cm)