TOA Electronics N-CC2564 8.2. Mounting Procedures

Camera direction

Secure these two holes first.

(Base unit mounting holes)

Open

Ceiling surface

Mounting screws

Ceiling surface

Camera direction

2. Release the lock on the hinged portion of the base unit, and connect the composite cable and power cable

to the base unit. (For details, please refer to p. 30; "CONNECTIONS.")

8.2. Mounting Procedures

1. Mount the base unit to the ceiling.

First fix two of the base unit mounting holes as shown below.

Since no mounting screws are supplied with the camera, prepare them separately.

Use screws with a nominal diameter of 4 mm and a length of over 25 mm.

Note: When routing cables over the ceiling surface, securely fix all 4 of the base unit mounting holes to the

ceiling.

Open Hinged portion

3. Push up and lock the hinged portion of the base unit and secure the remaining two mounting holes.

Contents

Main TABLE OF CONTENTS 1. SAFETY PRECAUTIONS Safety Symbol and Message Conventions CAUTION 2. LIST OF INCLUDED COMPONENTS AND PARTS 3. GENERAL DESCRIPTION 4. FEATURES 5. HANDLING PRECAUTIONS Page 6. NOMENCLATURE Page 7. PRECAUTIONS WHEN INSTALLING THE UNIT 8. DIRECT CEILING MOUNTING 8.1. Mounting Example 8.2. Mounting Procedures Page Page Page 9. MOUNTING THE CAMERA TO A WEAK CEILING PANEL 9.1. Mounting Example 9.2. Mounting Procedures * Page 10. FLUSH CEILING MOUNTING 10.1. Mounting Example 10.2. Mounting Procedures Page Camera direction Page 11. CEILING SUSPENSION 11.1. Mounting Example 11.2. Mounting Procedures Page Page Page Page 12. WALL MOUNTING 12.1. Mounting Example 12.2. Mounting Procedures Page 13. CONNECTIONS 13.1. Connection example 14. INITIALIZATION DIP SW1 DIP SW2 DIP SW3 OSD switch Note: If the DIP switches are not set correctly, the camera does not operate correctly. 14.1. DIP Switch Settings No.1 No.2 bps OFF OFF 38,400 O N OFF 19,200 OFF O N 9,600 O N O N 4,800 15. TROUBLESHOOTING 16. SPECIFICATIONS