TOA Electronics WM-4310A, WM-4310H Battery Insertion, Operation, Battery replacement

6. BATTERY INSERTION

Step 1. Holding the microphone body, slide	1
the battery cover down to open it. The

battery cover is designed not to be removed from the body.

Step 2. Insert the battery 6LR61 (Alkaline 9 V) according to the instructions attached to the inside of the battery compartment. Pay attention to the correct polarity when inserting the battery.

Step 3. Replace the battery cover.

Battery replacement

•A brand-new battery will provide the power enough to operate the unit continuously for 10 hours.

• As long as the battery has sufficient power for the microphone to function properly, the orange LED will light. When the orange LED starts to fade and then flash, replace it with a new one.

2

Power/Battery lamp (Orange LED)

7. OPERATION

Step 1. Plug the microphone's plug into the input connector as illustrated.

Step 2. Make sure that the receiver and the wireless microphone are of the same channel (frequency). Step 3. If they are not identical in channel, you have to adjust the channel switch.

Step 4. Press the microphone ON/OFF switch to turn on the microphone.

The orange LED indicates the circuit is active.

As for the WM-4310A, insert the main unit into the waist pouch as indicated by the arrow. The main unit's power switch should be located under the switch indication position (SW mark) of the pouch. When turning on the microphone, press SW mark on the pouch.

Step 5. Make sure to press the ON/OFF switch again to turn off the microphone after using.

Power switch position mark

4

1 Plug lock

Secure the connection with the plug lock.

Illustration for WM-4310A

5