II. INSTALLATION
IMPORTANT
IT IS THE CUSTOMER’S RESPONSIBILITY TO REPORT ANY CONCEALED OR
A.Assembly
1.Thread the 4” (102mm) legs into the four holes on the bottom of the toaster. See Figure 2. Then, place the toaster in the desired location.
2.Install the entry rack and crumb tray into the front of the toaster, as shown in Figure 2.
Figure 2 - Basic assembly and
Entry rack
hanger rods fit
into holes on toaster body
Return tray
slides underneath
toaster
Legs (4) |
|
thread into holes | Crumb tray |
in bottom of | slides into opening |
toaster | in front of toaster |
3.TOASTERS INTENDED FOR
Position the return tray underneath the toaster, as shown in Figure 2. Note that the return tray extends past the FRONT of the toaster during
4.TOASTERS INTENDED FOR
• Remove the CENTER screw from the rear panel of the toaster, as shown in Figure 3.
• Push the rear panel forward into the toaster.
• Position the return tray underneath the toaster as shown in Figure 3. Note that the return tray extends past the REAR of the toaster during
Figure 3 - Electrical connection and
2. Adjust
panel
Serial plate
1. Remove
screw
Return tray
slides underneath
toaster
B.Electrical Utility Connection
IMPORTANT
THE ELECTRICAL CONNECTION TO THE TOASTER REQUIRES A CIRCUIT BREAKER/FUSED DISCONNECT. ELECTRICAL SPECIFI- CATIONS ARE LISTED ON THE SERIAL PLATE (SHOWN IN FIGURE 3), AND IN THE ELECTRICAL SPECIFICATIONS ON PAGE 1 OF THIS MANUAL.
CONSULT ALL APPLICABLE NATIONAL AND LOCAL CODES FOR FURTHER ELECTRICAL CONNECTION REQUIREMENTS.
1.Before proceeding with the electrical connection, check the following:
a.Check that the electrical supply matches the toaster’s requirements. Refer to the toaster’s serial plate (Figure 3) and to the Electrical Specifications on Page 1.
b.Check that the appropriate receptacle is available for the power cord plug.
WARNING
ENSURE THAT BOTH THE CIRCUIT BREAKER/FUSED DIS- CONNECT AND THE PRODUCT SELECTION KNOB ARE IN THE OFF (“0”) POSITION BEFORE PROCEEDING.
WARNING
ENSURE THAT ANY PACKING MATERIAL RESIDUE HAS BEEN REMOVED FROM INSIDE THE TOASTING CHAMBER.
3.Insert the power cord plug into its receptacle.
III. OPERATION
A.Location and Function of Controls
This section provides a basic description of the toaster controls, their location, and the functions they perform. The operator MUST be familiar with the controls. Refer to Figure 4.
Figure 4
1. Product | 2. Conveyor |
selection knob | speed control |
| knob |
1.Product Selection knob
•When set to TOAST ( 
), switches on the conveyor, the upper heating element, and one lower heating element.
•When set to OFF (“O”), switches off the conveyor and all heating elements.
•When set to BUNS/BAGELS ( 
), switches on the conveyor and both of the lower heating elements.
2.Conveyor Speed Control knob
Adjusts the speed of the conveyor. This controls the amount of toasting that the bakery product receives.
•“1” is the minimum speed setting, which produces a darker toasting of the bakery product.
•“9” is the maximum speed setting, which produces a lighter toasting of the bakery product.
