Boil-Dry Protection

A safety thermostat will automatically operate should your Kettle be accidentally plugged in without any water, or if the Kettle is without sufficient water, or if the Kettle is allowed to boil dry. To reset the boil- dry protection device you must remove the Kettle from the Power Base and allow it to cool before refilling with water.

User Maintenance Instructions

The Lumens® Electric Kettle requires little maintenance. It contains no user-serviceable parts. Do not try to repair it yourself. Any servicing requiring disassembly other than cleaning must be performed by a qualified appliance repair technician.

CLEANING

CAUTION: Always unplug Kettle and allow to cool before cleaning. Never immerse Kettle, Power Base, cord, or plug in water or other liquids. Never use scouring pads or harsh cleansers to clean your Kettle as they may damage the surface.

1.Make sure the Kettle is unplugged and completely cool.

2.Grasp the Handle and remove the Kettle from the Power Base. If necessary, wipe the inside and outside of the Kettle with a soft, damp cloth and wipe dry.

3.To remove the Filter, first raise the Lid. Firmly push the top of the Filter forward

to release it, then pull it straight up and out. Rinse the Filter under running water. If necessary, use a soft brush to loosen any scale deposits. Heavier deposits may require soaking in a water/vinegar solution. Do not wash in dishwasher.

4.To reinstall the Filter, turn the Filter so

that the top tabs are facing inside the Kettle. Align the slot on the bottom of the Filter with the inside slot below the spout. Press down on the Filter and press it forward firmly into the spout, allowing it to snap in place.

5.Wipe the Power Base with a damp cloth.

6.Make sure both the Power Base and Kettle are completely dry after cleaning and before use.

7.Wrap the Power Cord around the Cord Storage Area beneath the Power Base for storage purposes.

7.