SECTION 3 - OPERATION
D. CLEARING JAMS
WARNING
NEVER INSERT YOUR HANDS INTO THE TOASTING CHAMBER TO CLEAR A JAM. SERIOUS INJURY MAY RESULT.
CAUTION
NEVER use a plastic object to clear a jam. If the toaster is not completely cool, damage to the toaster may result.
CAUTION
When clearing a jam, use care to avoid damaging the heating elements.
1.Switch the ON/OFF/STANDBY knob to the “OFF” position.
2.Disconnect electrical power to the toaster at the circuit breaker/fused disconnect.
3.Allow the toaster to cool.
4.Carefully clear the jam using a long object as a probe. This object should preferably be made of wood, which is less likely to damage the heating elements.
E. DAILY CLEANING
WARNING
WHEN CLEANING THE TOASTER, NEVER APPLY ENOUGH LIQUID TO STAND IN PLACE ON THE UNIT. DO NOT SPRAY, RINSE, OR SUBMERGE THE TOASTER. EXCESSIVE MOISTURE IN THE UNIT WILL CAUSE A SEVERE ELECTRICAL HAZARD AND MAY OTHERWISE DAMAGE THE TOASTER.
CAUTION
DO NOT clean your toaster using abrasive cleaners or pads. Both will scratch and dull the finish.
1.With the conveyor running, use a brush to clean any crumbs off the conveyor into the
2.Switch the ON/OFF/STANDBY knob to the “OFF” position.
3.Disconnect electrical power to the toaster at the circuit breaker/fused disconnect.
4.Allow the toaster is cool.
WARNING
DO NOT TOUCH HOT SURFACES ON THE TOASTER, OR REACH INTO THE TOASTING CHAMBER, UNTIL THE UNIT HAS COOLED THOROUGHLY.
5.Wipe the exterior of the toaster with a sponge or cloth soaked in hot or warm detergent water. Wipe with a clean, damp cloth to remove the excess detergent, and then wipe again to dry the toaster.
6.Remove both the
CAUTION
Never remove the
7.Remove the entry and exit racks from the toaster. Wash the racks in warm detergent water, and rinse them.
8.Towel the trays and racks dry. Reassemble all parts onto the toaster.
