11
4. Grasp slack thread (while
removing slack); guide the thread
into the center groove in disc
thread guide “C”. NOTE: Make
sure that thread does not slip
behind the guide.
Pull about 6” of thread through
and ensure that the threading is
correct up to this point.
5. Turn the hand wheel toward you
until take-up lever is in its highest
position. Pass the thread through
the hole in take-up lever “D” from
right to left.
6. Turn the hand wheel toward you
so that needle lowers and the
thread guide “E” is accessible.
Place the thread behind the
thread guide “E” to the right side
and pull forward. The thread
guide will thread itself.
7. Turn the hand wheel toward you
again to raise the needle to its
highest position.
Feed wire needle threader
through needle eye from right to
left.
Insert thread through wire loop and pull
needle threader through the needle eye.
Now pull thread back to the right.
The needle is now threaded.