WINDING A BOBBIN
x Place spool of thread onto spool pin. x Press spool holder ring against spool.
CAUTION: Spool of thread should be rotated freely after pressing the holder ring on.
x Lead thread to Guidepost (1) and draw to the left under pretension stud (2).
x Draw thread between the two tension discs of thread tension dial, then pull thread to right as shown.
x Follow arrows. Guide thread through guidepost (3).
x Open the bobbin winder cover and in- sert a bobbin.
x Align the small bobbin hole on pin of bobbin winder.
x Follow arrows. Manually wind thread clockwise around the bobbin
x Still holding end of thread, push on/off switch and start to wind
x Trim the end of the thread after bobbin is wound around a few times.
x Continue to wind bobbin until desired amount is reached and cut thread.
CAUTION: Do not
5
