Topcom Butler 3200 / Twin / Triple / Quattro
6.4 ERASING A NUMBER FROM THE CALL LIST
•Scroll through the Call list until the desired number is shown on the display.
•Press and hold the Mute button 
for 3 sec. to erase the number.
6.5 STORE A NUMBER FROM THE CALL LOG INTO THE MEMORY
•Scroll through the Call list until the desired number is shown on the display.
•Press and hold the Memory button 
for 3 sec.
•Enter the memory location
•Enter the Memory button 
again to confirm and to go back to standby
7. REGISTER/DE-REGISTER A HANDSET
7.1 REGISTER TO A TOPCOM B3200 BASE
You can subscribe 5 handsets to one base unit. By default, each handset is subscribed as handset 1 on the base unit upon delivery (base unit 1).
!!! You only need to subscribe the handset if: !!!
•The handset subscription has been removed from the base unit (e.g. for reinitialisation)
•You want to subscribe a different handset to this base unit.
The underlined procedure is only applicable to a Topcom Butler 32xx handset and base unit!! Keep the Paging key on the base unit pressed for 10 seconds until the Line/Charge indicator on the base unit begins to blink rapidly. The Line/Charge indicator will blink rapidly
for one minute. During this minute, the base unit is in register mode and you must do the following to subscribe the handset:
•Press and hold the 
and 
key for 3 sec.
•The following will appear on the display:
•Enter the number of the base unit you would like to subscribe the handset to
•The unit will start searching for the base and when found it will ask to enter the pin code (4 digits):
•Enter the base pin code (0000). If the pin is wrong, the handset will restart the searching for the base.
•When the handset is registered, it will show ‘HS’ followed by the handset number.
7.2 SUBSCRIBING A TOPCOM BUTLER 300 DECT GAP HEADSET
Press the Paging key on the base unit for 10 seconds until the Line/charge indicator on the base unit starts to blink quickly. The line/charge indicator will blink quickly for one minute. During this minute, the base unit is in subscribing mode and you must do the following to subscribe the headset:
-Turn ON the headset by pressing the ON/OFF button until you hear two beep tones. At the same time the red and green LED will lit ones.
-Remove the rubber cover of the power socket so that the hole of the power socket is free. Pull out the rubber cover from the headset so that the registration key hole is free also.
-Press the headset registration key. The red LED will flash rapidly.
-If after a few seconds the green LED flashes slowly, the registration is successful.
-If the red LED flashes slowly, the registration is failed. Repeat above procedure.
10 | Topcom Butler 3200 / Twin / Triple / Quattro |
