Topcom Butler 3300/Twin/Triple/Quattro 13
Topcom Butler 3300/Twin/Triple/Quattro
ENGLISH
• Enter the number of the base unit you would like to subscribe the handset to (1-4)
• The unit will start searching for the base and when found it will ask to enter the pin code
(4 digits):
• Enter the base pin code (0000). If the pin is wrong, the handset will restart the searching
for the base.
• When the handset is registered, it will show ‘HS’ followed by the handset number.
7.2 Subscribing a Topcom Butler 300 DECT GAP Headset
Press the Paging key on the base unit for 10 seconds until the Line/charge indicator on the
base unit starts to blink quickly. The line/charge indicator will blink quickly for one minute.
During this minute, the base unit is in subscribing mode and you must do the following to
subscribe the headset:
• Turn ON the headset by pressing the ON/OFF button until you hear two beep tones. At
the same time the red and green LED will lit ones.
• Remove the rubber cover of the power socket so that the hole of the power socket is
free. Pull out the rubber cover from the headset so that the registration key hole is free
also.
• Press the headset registration key. The red LED will flash rapidly.
– If after a few seconds the green LED flashes slowly, the registration is successful.
– If the red LED flashes slowly, the registration is failed. Repeat above procedure.
7.3 Removing a handset
You can remove a handset from a base to allow another handset to be registered:
• Press and hold the key for 3 sec, then press and hold the key for 3 sec.
• Enter the pin code (0000). If the pin is wrong, the handset will go back to standby.
• Enter the handset number (1-4) you want to remove
• The unit will go back to standby is the removal is successfully. If not, it will ask again to
enter the handset number
PINPIN 1234H