Topcom Butler 4850/Twin/Triple/Quattro

8 Register/de-register a handset

8.1Register to a Topcom B4850 base

You can subscribe 4 handsets to one base unit. By default, each handset is subscribed as handset 1 on the base unit upon delivery (base unit 1).

!!! You only need to subscribe the handset if:

The handset subscription has been removed from the base unit (e.g. for reinitialisation)

If yYou want to subscribe a different handset to this base unit.

The below procedure is only applicable to a Topcom Butler 48xx handset and base unit!! Keep the Paging key on the base unit pressed for 10 seconds until the Line/Charge indicator on the base unit begins to blink rapidly. The Line/Charge indicator will blink rapidly for one minute. During this minute, the base unit is in register mode and you must do the following to subscribe the handset:

Press Menu button ￿Use the Right button to scroll to ‘REGISTER’ and press OK

￿Enter the number of the base unit you would like to subscribe the handset to (1-4) ￿ The unit will start searching for the base and when found it will ask to enter the pin code (4 digits):

￿Enter the base pin code (0000) and press OK . ￿ If the pin is wrong, the handset will restart the searching for the base. ￿ When the handset is registered, it will show ‘HS’ followed by the handset number.

8.2Removing a handset

You can remove a handset from a base to allow another handset to be registered:

Press Menu button ￿Use the Right button to scroll to ‘REMOVE HS’ and press OK ￿ Enter the pin code (0000) and press OK ￿ Enter the handset number (1-4) you

want to remove and press OK . ￿ The unit will go back to standby is the removal is successfully. If not, it will ask again to enter the handset number

You can only remove existing handsets and others then the one you are using.

ENGLISH

Topcom Butler 4850/Twin/Triple/Quattro

15

Page 15
Image 15
Topcom manual Register/de-register a handset, Register to a Topcom B4850 base, Removing a handset