Topcom BPM 2301b
9.3Measurement
•Press ‘POWER’. All digits will light up, checking the display functions. The checking procedure will complete after about 2 seconds.
•After all symbols disappear, the display will show "0" with the designated Memory Zone. At this time, the monitor is "Ready to Measure".
•Press ‘PAGE’ to select if the result must be stored in memory zone 
or 
. (see §9.4)
•Press ‘START’. Once the monitor automatically inflates the cuff to approximately 180 mmHg, the measurement will begin.
•When the measurement is completed, systolic, diastolic and the Pulse Rate will be shown simultaneously on the LCD screen (see §7).
•When a mistake was detected during measurement the Error mark ‘Err’ appears on the display (see §12).
•After deflation, the measurement of blood pressures is completed. Press ‘POWER’ button to switch off electrical supply.
•If you forget to push the ‘POWER’ button, the power will turn off automatically within 3 minutes.
60
