22 23

Mira 200 Mira 200
9.6. RECORDING TIME PER MESSAGE
The maximum recording time has been pr eset to 2 minutes (d2). In order to change
this setting, proceed as follows:
1. Br ing the devic e in programm ing m ode so that the previousl y progr ammed
recording time appears on the display.
2. In order to change the recording time, p ress the playback/fast forward
button. On the display the possible choices appear (d0-d2,d-):
d0= 30 seconds, d1= 1 minute, d2= 2 minutes, d-= no limit.
3. Press the STOP button to end the programming or the /PROG button to pass
to the following setting.
9.7. REMOTE CONTROL CODE
The code number for the remote control consists out of 3 numbers and is preset to
“123”. In order to change this code, proceed as follows:
1. Bring the device in programming mode so that “Cd” appears on the display.
2. In order to change the first number, press the rewind button. The previous-
ly entered number appears on the display. The indication “-” shows that it concerns
the first number.
3. Press the playback/fast forward button to change the number (0-9).
4. In order to change the second number, press the rewind button. The previ-
ously entered number appears on the display. The indication “=“ shows that it con-
cerns the second number.
5. Press the playback/fast forward button to change the number (0-9).
6. In order to change the third number, press the r ewind button. The previ-
ously entered number appears on the display. The indication “ ” shows that it
concerns the third number.
9.4. PROGRAMMING MODE
The following settings can be changed in the programming mode.
* Number of rings before automatic answering
* Recording time per message
* Remote control code
* Speech quality
In order to bring the device in prog ramming mode, press and hold the / P R O G
button until you hear a beep. The PROG-LED on the base station will light and on the
display the previously entered number of rings appear. Each time you want to go to a
following setting, press and release the /PROG button, the previously entered coor-
dinates appear on the display.
To stop the programming, press the STOP button. The PROG-LED turns off.
9.5. SETTING THE NUMBER OF RINGS
You can determine yourse lf after how many rings you r Mira 200 will answer th e
incoming calls. Standard this has been set to 2 rings (r2). In order to change this set-
ting, proceed as follows:
1. Bring the Mira 200 in programming mode so that the previously entered number of
rings appear on the display.
2. To change the number of rings, press the playback/fast forward button. On
the display the possible choices appear (r1-r5, ts):
r1= 1 ring, r2= 2 rings, r3= 3 rings, r4= 4 rings, r5= 5 rings, ts= toll saver
(the call is answered after 2 rings when messages have been recorded and after 4
rings when no messages have been recorded, see 10. Remote control).
3. Press the STOP button to end the programming or the /PROG button to pass
to the following setting.