ASSEMBLY
STEP 3:
A
Slide Engine Mount Arm (B) into the receiver on the Mount Plate (A) and fasten by dropping in ball pin (#J0248). Place Engine/ Blower Assembly onto Engine Mount Arm (B) and fasten with (4)
STEP 4:
The ears of the Cone (A) should fit underneath the two threaded bosses on the Blower Face (B). Secure with (2)
TIGHTEN CONE BOLTS BEFORE EACH USE!
B
PECO
B
A
Impeller Blade Replacement
To remove: Remove hex bolts from hub then screw the bolts
into threaded holes to remove old blade. | B |
| |
(This will push the impeller off the hub.) If the A |
|
impeller is stuck on hit the base of the impeller |
|
between each vein with a hammer then try the |
|
bolts again. |
|
To replace: Place tapered bushing (A) into hub (B) and align
Secure with two 1/4" x 1" hex bolts. Torque to 15 ft. lbs.
MODEL 22610709 - 12 TORO | 2001 | PECO 5 |