1

SQUEEZE

2

1531

Figure 2

1. Upper tubing

2. Lower tubing

 

 

3.Carefully insert the left side of the upper tubing into the end of the lower left side tubing (Fig. 2).

4.Squeeze the upper tubes together, and wiggle the upper tubes down until the mounting holes in the upper and lower tubing line up (Fig. 2).

5.Place the mounting plate over the tubes (Fig. 3). Align the mounting plate holes with the upper and lower tubing holes.

21

4

3

1532

 

 

Figure 3

 

1.

Mounting plate

3.

Chute crank

2.

Shroud

4.

Gear

 

 

 

 

6.Insert the end of the chute crank through the hole in the shroud. Turn the chute crank rod lightly until the flattened end drops into the slot in the gear. Firmly push the chute crank into the gear until it snaps into place (Figs. 3 and 4).

2

1

1533

Figure 4

1. Chute crank

2. Chute crank gear

 

 

7.Secure the upper and lower tubing and the mounting plate together with 2 machine screws and locknuts.

Note: Position the screw heads on the outside of the mounting plate. Be careful not to damage the internal electrical wiring when you insert the screws. If the wiring blocks the hole, use a blunt 1/8-in. punch to carefully route the electrical wiring away from the aligned holes.

Installing the Discharge Chute

1.Position the chute deflector onto the discharge chute and align the mounting holes (Fig. 5).

1

 

 

 

5

 

 

 

6

 

 

 

2

 

4

 

 

 

3

 

1534

 

 

 

 

 

Figure 5

 

1.

Chute deflector

4.

Carriage bolt (2)

2.

Discharge chute

5.

Metal washer (2)

3.

Rubber washer (2)

6.

Locknut (2)

 

 

 

 

2.Insert 2 rubber washers between the chute deflector and the discharge chute while maintaining the hole alignment (Fig. 5).

5

Page 5
Image 5
Toro 3.80E+13 manual Installing the Discharge Chute