Programming the Remote Control

●This Remote Control is preprogrammed to operate TOSHIBA VCR’s.

●To use VCR’s other than TOSHIBA models (or cable converter), perform the following procedures before operating.

Set up

RECALL MUTE

POWER RECALL

Controlling other brands of VCR’s and cable TV converters

1 Refer to the “VCR code table” (or “Cable TV converter code table”) on pages 12 and 13 to find the code number that corresponds to

Preparation

oPOWER

1

2

3

 

4

5

6

Number

 

the brand name of your VCR (or converter).

If more than one number is listed, try each one separately until you find the one that works.

7 8 9

CH RTN

100 0 ENT

CH

VOL MENU/ VOL

ENTER

CH

TV

CABLE

VCR EXIT

FAV CH TV/VIDEO

A

REC TV/VCR STOP PLAY

STILL SOURCE PIP

SLOW PAUSE REW FF

PIP CH LOCATE SWAP

2 Set the TV/CABLE/VCR switch to “VCR” (or “CABLE”).

3 Hold down RECALL while pressing the Number buttons for the three digit code number for your brand of VCR (or converter).

4 Point the Remote Control at the VCR (or at the converter) and press POWER to test the code number.

–If the right number was entered, the VCR (or the converter) should turn off.

–If the VCR (or the converter) does not respond to the Remote Control, repeat steps 1 to 4 with another code number.

For future reference, write down the code numbers you used:VCR CODECABLE CODE

Notes:

●You have to reprogram the Remote Control when you change its batteries.

●Some newer VCR’s are capable of working on either of two remote codes. These VCR’s have a switch labeled “VCR1/VCR2”.

If your VCR has this kind of switch, and does not respond to all the code numbers for your VCR brand name, set the switch to another position (“VCR1” or “VCR2”) and reprogram the Remote Control.

Reference Section Advanced Operation Basic Operation

11