1/2
SETUP
Language English
Country UK
Auto tuning OK
Manual tuning OK
Antenna Amplifier On
AV connection OK
MENU
Back
EXIT
Watch TV
Input selection and AV connections
31
Defining the INPUT and OUTPUT sockets so that the television recognises connected equipment. See page 6
for a clear view of the back connection recommendations.
Most media recorders and decoders send a signal
through the SCART lead to switch the television to the
correct Input socket.
Alternatively press the external source selection button
Buntil the picture from connected equipment is shown.
This button must be used to view equipment connected
using the COMPONENT VIDEO INPUT (EXT3C).
An Sin the display e.g.B2S (EXT 2S), indicates the
input is set for an S-Video signal.
Use the Input Selection if the television does not switch
over automatically.

Input selection

1
This specifies the type of signal going into SCART 2 (EXT2)
on the back of the television. Please refer to the
manufacturers instructions for the connected equipment.
In the SET UPmenu press Quntil
AV connectionis highlighted, then press OK.
With Sor Rselect either AV or S-VIDEO as the
required inputfor EXT2.
If the colour is missing try the alternative setting.

INPUT signal selection

1
2
2
Press Bto select B1, B2, B3(C)(EXT1-3),
HDMI1,HDMI2or PC.
HDMI™ displays equipment connected to Input
HDMIon the back of the television. It is designed
for best performance with 1080i high definition
signals.
PC displays a computer connected to Input
RGB/PCon the back of the television.
To return totelevision mode press and hold B
and then select DTVor AT V.
AVconnection
PC/HDMI1 audio PC
HDMI1 audio Digital
EXT1 output DTV
EXT2 input S-VIDEO
EXT2 output DTV
Monitor (Audio) Fixed
MENU
Back
EXIT
Watch TV
This is a digitaltelevision which is integrated to allow the
use of both digitaland analogue services. However,
during the lifetime of this set it is very likely that
analogueservices will be switched off to allow for more
new digitalservices.
This ‘switch-off’ will happen in a number of phases,
which will be advertised in your area well in advance.
It is recommended that at each phase the television is
re-tuned to ensure that existing and new digital
services can be viewed without disruption
(see the 'Auto tuning' section).

Analogue switch-off

gg