7
Installing additional memory (optional)
RG 5.375 x 8.375 ver 2.3.4
Installing additional memory (optional) Before you install or remove a memory module, turn off the computer using
the Start menu. If you install or remove a memory module while the
computer is in Standby or Hibernation mode, data will be lost.
A memory module must be installed in slot A. Do not try to operate the com-
puter with a memory module in slot B only.
If you install a memory module that is incompatible with the computer, a
beep will sound when you turn on the computer. If the module is installed in
slot A, there will be a long beep followed by a short beep. If the module is in
slot B, there will be a long beep followed by two short beeps. In this case,
turn off the computer and remove the incompatible module.
Your computer comes with enough memory to run most of today’s popular
applications. You may want to increase the computer’s memory if you use
complex software or process large amounts of data.
Additional memory comes in various capacities (visit Toshiba’s Web site at
toshiba.com for more information). There are two memory slots. Your
system may have both slots occupied.
If you use the computer for a long time, the memory modules will become
hot. If this happens, let the modules cool to room temperature before you
replace them.
You need a standard Phillips no. 1 screwdriver to install a memory module.
To avoid damaging the computer’s screws, use a standard Phillips no. 1
screwdriver that is in good condition.
If you are adding memory after you have started to use the computer, begin
at step 1, otherwise skip to step 2.
1Turn off the computer via the Start menu.
See “Turn Off or Shut down command” in your electronic user’s
guide.
The operating system turns off the computer.
2Unplug and remove any cables connected to the computer.
3Close the display panel and turn the computer upside down to locate
the memory slot cover.