5. LOADING THE MEDIA
5. LOADING THE MEDIA
4.Put the media on the supply shaft.
5.Pass the media around the damper, then pull the media towards the front of the printer.
6.Insert the ridge of the supply holder into the groove of the supply shaft until the media is fixed. Then turn the locking ring clockwise to secure the supply holder. This will centre the media automatically. NOTE: Do not over tighten the locking ring of the supply holder.
| Groove Ridge | |||
Damper |
|
|
| Projection |
| Supply Holder | |||
| Media | |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Supply Shaft
Fig.
7.Insert the media into the paper holders of the media guide, adjust the media guides to the media width, and tighten the locking screw.
8.Check that the media path through the printer is straight. The media should be centered under the print head.
Media Guide
Media | Supply Holder |
| Media Guide |
| Paper Holder |
Paper Holder | Print Head |
Locking Screw | Media |
Fig.
NOTE: When using the label rolled with labels facing outside, please remove the upper plates of both paper holders using the following procedure. Failure to do this may cause a paper jam error.
If you have any questions, please contact your nearest TOSHIBA TEC service representative.
