APPENDIX 1 MESSAGES AND LEDS
ENGLISH VERSION EO1-33048
APPENDIX 1 MESSAGES AND LEDS
EA1- 1
APPENDIX 1 MESSAGES AND LEDS
Appendix 1 describes the LCD messages displayed on the operation panel.
Symbols in the message
1: : The LED is illuminated. ~: The LED is flashing. z: The LED is unlit.
2: ****: the number of unprinted media. Up to 9999 (in pieces)
3: ###: Flash memory card remaining memory for PC save area: 0 to 895 (in K bytes)
4: &&&&: Remaining flash memory capacity for storing writable characters 0 to 3147 (in K by tes)
LED Indicatio
n
No.
LCD Message
ONLINE ERROR
Printer Status
Restoration by
RESTART ke
y
Yes/No
Acceptance of
Status Request
Reset Command
Yes/No
ON LINE z Online mode ----- Yes
1 ON LINE ~ z Online mode (communicating) ----- Yes
2 HEAD OPEN z z The Top Cover is opened in online mode. ----- Yes
3 PAUSE **** z z Pause state Yes Yes
4 COMMS ERROR z A parity, overrun, or framing error has
occurred during a communication by RS-
232C.
Yes Yes
5 PAPER JAM **** z A paper jam has occurred during paper
feed. Yes Yes
6 CUTTER ERROR**** z A problem has occurred at the cutter
module. Yes Yes
7 NO PAPER **** z The media has run out, or the media is not
loaded properly. Yes Yes
8 HEAD OPEN **** z A feed or an issue was attempted with the
Top Cover opened. (Except when the
[FEED] key is pressed.)
Yes Yes
9 HEAD ERROR z The print head has a problem. Yes Yes
10 EXCESS HEAD TEMP z The print head is overheated. No Yes
11 RIBBON ERROR**** z
• The ribbon has run out.
• The ribbon has been torn. A problem has
occurred with the sensor that determines
the torque for the ribbon motor.
Yes Yes
12 COVER OPEN **** z A feed or printing was attempted with the
Front Cover opened. Yes Yes
13 SAVING ####&&&& z In writable character or PC command save
mode ----- Yes
14 FLASH WRITE ERR. z An error has occurred in writing to the flash
ROM. No Yes
15 FORMAT ERROR z An error has occurred in formatting the
flash ROM. No Yes
16 FLASH CARD FULL z Saving failed because of an insufficient
capacity of the flash ROM. No Yes
17 Display of error
message (See Note.) z A command error has occurred in analyzing
the command. Yes Yes
18 POWER FAILURE z A momentary power failure has occurred. No No
19 INTIALIZING… z z The flash ROM is being initialised. ----- -----
20 EEPROM ERROR z Data cannot be read from/written to a
backup EEPROM properly. ----- -----