Introduction
Connecting
your TV
Using the
Remote Control
Setting up
your TV
Using the TV’s
Features
Appendix
Index
57
(E) 46HM84 52HM84 62HM84
How to replace the lamp unit
Required tool: Manual Phillips screwdriver; gloves.
Optional tool: 5/32” or 4mm Allen wrench.
1.Turn off the TV and unplug the power cord.
2.STOP! Allow the lamp to cool for at least one (1) hour before
replacing it.
3.On the lamp unit door on the side of the TV, loosen the thumb
screw by hand or by using a 5/32” or 4mm Allen wrench, and then
remove the lamp unit door.
WARNING: Eye damage may result from
directly viewing the light produced by this
lamp. Always turn off the TV and unplug the power cord before
opening the lamp unit door.
Lamp unit screws
(Continued on next page)
TV back
Thumb
screw
Lamp unit door detail
WARNI NG: RISK OF
ELECTRIC SHOCK!
TO RED UCE TH E RISK OF ELECTRI C SHOCK,
NEVER REMOVE TV COVERS, EXCEPT AS
SPECIFIED HEREIN. REFER ALL SERVICING
NOT SPECIFIED IN THI S MANUAL TO
QUALIFIED SERVICE PERS ONNEL. Failure
to follow this WARNING may result in death
or serious injury.
CAUTION: HOT SURFACE
The temperature of the lamp immediately
after use exceeds 392˚F (200˚C). Touching the lamp before it has
cooled will result in severe burns. ALLOW THE LAMP TO COOL
FOR AT LEAST ONE (1) HOUR BEFORE R EPLACING IT.
4.
Using a manual Phillips screwdriver, loosen the two screws on the
lamp unit.
WARNI NG:
RISK OF
ELECTRIC SHOCK!
The lamp
unit door is provided with an interlock to
reduce the risk of electric shock and excessive ultraviolet
radiation. Never defeat its purpose or attempt to service
without removing the lamp unit door completely. Failure
to follow this WARNING may result in death or serious injury.
46,52,62HM84(E)56-60 6/21/04, 9:56 AM57