GA-1170 UNPACKING AND INSTALLATION
3 – 1
[ 3 ] UNPACKING AND INSTALLATION

1. UNPACKING

2. PACKAGED GOODS

3. INSTALLATION PROCEDURE

This installation procedure is provided for e-STUDIO162/162D,
e-STUDIO151/151D.
For Installation to other models, see the operation manual of the main
unit or the service manual.
Turn off the main switch of the main unit and remove the power
plug of the copier from the outlet.

1. Cut the r ear cabinet.

1) Remove the ADF/ RADF from the main unit and gently place it on
the document glass as shown in the illustration.
2) Cut out two cut-out portions from the rear cabinet using a cutter or
the like.
3) Use a Phillips screwdriver or the like to open a hole.
4) Remove the screw and then remove the rear cabinet cover.
5) Cut out a part of the rear cabinet cover with nippers or the like as
shown in illustration.
(Be careful about the orientation of the nippers so that the cross
section is flat.)

2. Attach the network expansion kit.

1) Engage the two pawls on the rear of the network expansion kit with
the cutout portions of the main unit and secure the kit with the sup-
plied screw (3 x 14).
2) Connect the connector of the network expansion kit to the connec -
tor of the main unit.
3) Secure the rear cabinet cover to the main unit with the screw.
4) Attach the ADF/ RADF to the main unit.
The unpacking and set-up procedure shall be done by a qualified
service technician.
Parts included
CD-ROM ... 3 pcs.
Screw (3 x 14) ... 1 pc.
USB cable ... 1 pc.
Network
expansion kit
Clamp ... 1 pc.
Important
information ... 1 sheet
sec03.fm 1 ページ ２００５年１月２５日　火曜日　午前１０時５５分