Getting Started
4
Getting Started
The battery comes pre-installed in the camcorder, however you must
remove the protective film on the battery before use.
1Slide the safety latch to the unlocked position and open the battery
cover.
2Insert the battery according to the correct polarity marks (+ or -).
Remove the protective film on the battery connection before use.
3Close the battery cover firmly and slide the safety latch to the locked
position.

Inserting and removing an SD™ Card (optional)

Your camcorder comes with internal memory that allows you to store
pictures and movies. You can expand the memory capacity by using an
optional SD™/SDHC memory card.
1Insert the memory card into the slot until it locks in place as shown
below.
2To remove an installed SD™ card, gently press the card inward to
release it.
The card pops out slightly.
3Grasp the card and pull it straight out.
To remove the SD™ Card, press
the card inward to release it.
When the card pops out, grasp
Li-ion battery
it and pull it straight out.
GMAA00221011.book Page 4 Friday, March 26, 2010 12:20 PM