OneHome
Camera Integration Note
Manufacturer: | Toshiba |
|
|
Model Number(s): |
|
OneHome Versions: | 4.0.292 and later |
Comments: |
|
Document Revision Date: | 8/25/2008 |
|
|
OVERVIEW AND SUPPORTED FEATURES
Installing the Toshiba camera can be broken down into the following steps:
1.Install cameras at desired locations, and pull power and Cat5 cabling as needed. Refer to the Toshiba documentation for mounting details.
2.Connect the cameras electrically to the home network and configure the cameras. See Camera Configuration.
3.Integrate the cameras into the OneHome system and test proper operation. This step is outlined in HomeLogic Configuration Details.
THIS TOSHIBA CAMERA SUPPORTS THE FOLLOWING FEATURES:
Pan / Tilt: These cameras can be turned to see various locations.
Video Out: The camera includes an analog video output, which can be connected to an analog DVR to provide separate recording, or to a TV modulator to enable camera viewing on a television.
THIS TOSHIBA CAMERA DOES NOT SUPPORT THE FOLLOWING FEATURES:
Zoom: The OneHome software does not support the camera’s
Presets: The camera includes presets, but this feature is not currently enabled in the OneHome software.
Audio In: The camera includes a microphone jack, but the audio input is not currently supported in the OneHome software.
Input/Output: The camera includes an I/O connector for sensor inputs and alarm outputs. These are not supported by the OneHome system at this time.
Motion Detection: Motion Detection is not supported on this camera.
HomeLogic LLC 100 Hoods Lane Marblehead, MA 09145 Phone (781)
