Error code Phenomenon Possible cause Items to confirm / Countermeasures Precautions / Remarks
EA70
EA60
CC30
CC41
Turn the power OFF. Then check the gap between rollers on the buffer roller guide and the buffer tray while the
buffer roller is left lowered. If the gap does not reach 0.3 mm, replace the buffer roller guides (LVR-E-RLR-BUF)
on both front and rear sides.
3. Improper roller gap on the
buffer roller guide and buffer tray
2. Catching pad link arm
deformed, damaged or removed
(Paper is not aligned properly
because the link arm of the
catching pad is deformed,
damaged or removed.)
Check the gap within the range 7 mm from the edge of the buffer roller guide.
- When more than one
sheet of paper is
loaded on the buffer
tray, the first sheet is
pushed out of the tray
by the second sheet.
- When more than one
sheet of paper is
loaded on the buffer
tray, the leading edge
of the second sheet is
caught and thus a
paper jam occurs.
- When paper is
transported from the
buffer tray to the
finishing tray, the
paper is run on the
front or rear alignment
plate.
- When paper is
loaded on the finishing
tray, the front and rear
alignment plates
excessibly push the
paper.
- When paper is
transported from the
finishing tray to the
movable tray, the
paper exit guide
catches the paper and
thus a motor error
occurs because the
paper cannot exit.
Check if the catching pad in the Finisher paper exit section is properly attached. If its link arm is deformed,
damaged or removed, replace ARM-SOL-ALIGN (6LB100080).
Check if the catching pad in the Finisher paper exit section is properly attached. Replace it if it is deformed or
dama
g
ed.
1. Catching pad deformed or
damaged
(Paper is not aligned properly due
to the deformed or damaged
catching pad.) Abnormal
Facing down
Catching pad link arm
Normal
Catching pad
0.3 mm or
more
Within the range 7 mm
from the edge
Buffer roller
RLR-EXIT-BUFFER
Roller on the buffer tray
RLR-EXIT-TRY
Buffer roller guide
LVR-E-RLR-BUF
Buffer tray
Buffer roller guide
Buffer roller guide
㪍