4.29 Wireless LAN Antenna/Bluetooth Antenna/Display Cover 4 Replacement Procedures
Satellite A20 Maintenance Manual (960-444) 4-81
3. Pass the LCD cable through the hole from the top of the display assembly toward its
bottom.
4. Close the display cover and turn the display assembly face down.
5. Place the cable earth plate first and then place the cable hold plate on the display
cable and secure them with the following screws.
NOTE: Before securing, make sure the cable hold plate is securely fit to the
guide on the chassis.
• M2.5×6 TAPPING screw ×2
6. Install the display cover to the two hinges of the display assembly and secure it with
the following screws.
• M2.5×4 FLAT HEAD screw ×2
• M2.5×5 FLAT HEAD screw ×4
7. Place the metal plate on the LCD cable and secure it with the following screw.
• M2.5×4 TAPPING screw ×1
8. Install the latch assembly on the display cover. First, install the switch (light blue) on
the front side of the computer. Then, install the inside switch (dark blue) with spring
so that three slots of the inside switch are attach to the switch.
NOTE: When installing the latch assembly, move the switch several times to
check it is working properly. Make sure the switch interlocks the inside switch.