24/29 SD-R5112 Rev.1.0
9. Device Configuration Jumper
9.1. Device configuration jumper (MODE SELECT)
The device configuration jumper is a 6-pin, right angle and header (Molex P/N70203 or equivalent)
with three marked positions.
S M MC SC
S L A S L A
Cable CSEL
S L AS L A
MSC MSC
Vcc
GND
Drive CSEL
(a) (b) (c)Figure 15
(a) Use CS (CSEL)
The device shall use the host interface signal CSEL to configure the device.
(b) MA (Master): Default Position
The device shall use for the Master.
Default Mode is 'MA'.
(c) SL (Slave)
The device shall use for the Slave.