Contents
8.3.1 |
| Changing an instruction | 92 | |
8.3.2 |
| Inserting a column | 95 | |
8.3.3 |
| Deleting a column | 96 | |
8.3.4 |
| Inserting a line | 97 | |
8.3.5 |
| Deleting a line | 98 | |
8.4 |
| Writing into the PLC's memory | 100 | |
8.4.1 |
| Writing/replacing a rung | 100 | |
8.4.2 |
| Inserting a rung | 101 | |
8.4.3 |
| Deleting a rung | 102 | |
8.4.4 |
| 103 | ||
9. |
| Data Monitor Mode | 104 | |
9.1 |
| Displaying registers/devices in a block | 104 | |
9.2 |
| Data setting function | 107 | |
10. |
| Control Commands | 110 | |
10.1 |
| Entering the password | 111 | |
10.2 |
| Setting passwords | 112 | |
10.3 |
| Automatic l/O allocation | 114 | |
10.4 | Program read (RAM←lC card/EEPROM) | 115 | ||
10.5 | Program write (RAM→lC card/EEPROM) | 116 | ||
10.6 |
| Program load (HP→PLC) | 117 | |
10.7 |
| Program save (HP←PLC) | 118 | |
10.8 |
| Program compare (HP↔PLC) | 119 | |
10.9 |
| HALT | 120 | |
10.10 | RUN | 121 | ||
10.11 | 122 | |||
10.12 | Program check | 123 | ||
10.13 | HOLD set | 125 | ||
10.14 | HOLD reset | 126 | ||
10.15 | Clear memory | 127 | ||
10.16 | Clear force designation | 128 | ||
10.17 | Clear event history | 129 | ||
10.18 | ERROR reset | 130 | ||
10.19 | Buzzer ON/OFF | 131 | ||
10.20 | PLC connection | 132 | ||
10.20.1 | Direct connection | 133 | ||
10.20.2 | Network connection | 134 | ||
6 Handy Programmer(HP911)
