Lamp replacement (Continued)
1Unplug power cord.
2Wait until lamp is sufficiently cooled.
Wait for at least 1 hour.
3 Remove the lamp cover. |
| Lamp cover |
|
| |
Loosen the 2 screws, then pull up to the | 3 | 1 |
| ||
direction of the arrow with your fingers as |
| 2 |
shown to remove the lamp cover. Use care to |
| |
|
| |
avoid any damage to nails and/or tip of your |
|
|
finger(s). If you have any difficulty in removal, |
|
|
you can use a screwdriver or any other smaller |
|
|
tool for your convenience. |
|
|
4 Pull out the lamp. | 4 | 1 |
Loosen the 2 screws holding the lamp in place, | 2 |
and pull up the handle to remove the lamp.
5 Mount the new lamp.
Align the orientation, press down until the bottom is reached, and lock in place using the two lamp locking screws.
2
6 Replace the lamp cover. | 5 | 1 |
Align the cover, and press it in, then tighten the screws loosened in step 3 until the lamp cover is no longer loose.
7 Reset the lamp timer.
See the lamp’s manual for instructions on resetting the lamp timer.
Notes and Precautions
•Press the 
button twice to display (a rough guide) the time of lamp use, the Lamp time item, in the Status display menu. p.34
•It is recommended that the lamp be replaced after 3,000 hours of use. When Lamp time reaches 3,000 hours, the 
icon and a message will appear. This display disappears when you press 
button.
•Attach the lamp cover correctly so that it is not loose. If it is not attached correctly, the lamp may fail to come on p.38 , and the lamp’s lifetime may be shortened.
•Always replace the lamp with a new one.
•The lamp is made out of glass. Do not touch the glass surface with your bare hands, bang it, or scratch it. (Dirt, jolts, scratches and the like could break the lamp.)
Used Lamps
This projector’s lamps contain trace amounts of environmentally harmful inorganic mercury. Be careful not to break used lamps, and dispose of them in accordance with local regulations.
Lens and main unit cleaning
WARNING
•Request cleaning and maintenance of a
■ Lens cleaning
• Clean the lens with a commercially available blower and/or lens cleaner.
• The lens is easily scratched, so do not rub it with hard objects, or strike it.
■Main unit cleaning
•Clean the main unit after unplugging the power cord.
• Wipe dirt off the main unit gently with a soft cloth.
• Do not wipe the main unit with a damp cloth. Doing so may allow water to get inside, resulting in an electric shock or failure.
• Do not use benzene, thinner and the like as they may deform or discolor the unit or damage the paint surface.
•When using a chemically treated cloth, follow the precautions included with the cloth.
Maintenance
36 | 37 |
