Toshiba TDP T91, tdpT90 Connection, Placement

2120
Preparations
p.47
Before connection
•Read the owner’s manual of the device you are connecting to the projector.
•Some types of computer cannot be used or connected to this projector.
Check for an RGB output terminal, supported signal
p.45
, etc.
•Turn off the power of both devices before connecting.
•The figure below is a sample connection. This does not mean that all of these devices
can or must be connected simultaneously. (Dotted lines mean items can be exchanged.)
Notes
•COMPUTER terminals 1 and 2 function identically.
•For TDP-T91, the document camera should be connected to COMPUTER terminal 2.
•The AUDIO IN terminal doubles for devices connected to COMPUTER terminals 1 and 2.
Connection
Projection Distance and Size
Use the figures, tables, and formulas below to determine the projection size and projection distance.
(Projection sizes are approximate values for full-size picture with no keystone adjustment.)
Placement Styles
As shown in the figures below, this device can be placed in 4 different styles.
The factory setting is “floor-mounted front projection.” Set the Projection mode in the
default setting menu
p.32
, in accordance with your needs.
Placement
Floor-mounted front projection
WARNING
•Always obey the instructions listed in IMPORTANT SAFETY INSTRUCTIONS when placing the unit.
Attempting to clean/replace the lamp at a high site by yourself may cause you to drop down, thus
resulting in injury.
•If you wish to mount the projector on the ceiling, be sure to ask your dealer to do so. Mounting the
projector on a ceiling requires special ceiling brackets (sold separately) and specialized knowledge.
Improper mounting could cause the projector to fall, resulting in an accident.
•If the projector is ceiling-mounted, install the breaker for turning off the power in case of anomaly. Let
everyone involved with the use of the projector know that fact.
Floor-mounted rear projection
Ceiling-mounted front projection Ceiling-mounted rear projection
H
a
90°
Screen As seen from above
Lens center
As seen from the side
a (min length) = projection size (inches) × 4.064
a (max length) = projection size (inches) × 4.878
90°
Computer (for control)
VCR Video recorder,
DVD player, etc.
Audio amplifier, etc.
To RS-232C
terminal
Control cable
To audio output
White (L)/Red (R)
To video
output
AV cable
(not supplied)
Video cable (not supplied)
To S-Video
output
To audio output
White (L)/Red (R)
S-Video cable
(not supplied)
Audio cable
(not supplied)
To audio input
White (L)/Red (R)
To RGB
output
RGB cable
(not supplied)
Audio cable
(not supplied)
To audio
output
To Y/CB/CR output
Green (Y)/Blue (CB)/Red (CR)
Conversion adapter BNC-pin
(not supplied)
Monitor cable Mini
D-sub 15P-BNC
(not supplied)
RGB cable
(supplied with
TDP-T91)
To audio output
Audio cable
(not supplied)
RGB cable
(supplied)
To RGB output
ComputerDocument cameraComputer DVD video recorder, etc.
a is the distance (m) between the lens and the
screen, and corresponds to a range of 1.20 m to
10.00 m. H is the height from the image bottom to
the center of the lens.
projection projection distance a (m) height (H)
min length max length
size (inches) (zooming max) (zooming min) (cm)
24.6 — 1.20 5.6
40 1.62 1.95 9.1
60 2.44 2.93 13.8
80 3.25 3.90 18.3
100 4.00 4.88 22.9
150 6.10 7.30 34.3
200 8.10 9.76 45.7
246 10.00 — 56.2