Toshiba TLP-B2ultra owner manual Projection on the screen, Select the input source

Projection on the screen (Continued)					CONTENTS	26
3	RGB	or	VIDEO	Select the input source.
				On the remote control, press RGB or VIDEO.
		INPUT		On the control panel of the main unit, press INPUT
				repeatedly.
				Each time the button is pressed, the source indication on the
				screen changes as follows:
				: To project pictures from a computer connected to RGB
				connector.
		or		: To project pictures from a video player connected to VIDEO
				connector or S-VIDEO connector.
				(Signal sent from the computer)
				• If you project an image from a computer with an LCD screen
				while monitoring the image on the computer, the image may not
				be projected properly, depending on the computer model.
				In this case, turn off the computer display. For details on
				controlling the computer display, etc., refer to the computer’s
				manual and description on the software for the computer used.
				• When a signal of the blackish screen whose edges are dark is
				input, it may not be displayed normally. If this happens, input a
				signal whose picture is bright and whose frame is clear, then
				press the remote control unit’s RGB button again.
				• The projector projects an image by XGA signal (1024 x 768) in
				full screen.
				• VGA, SVGA signal project the image by enlarging in full screen
				size, the image quality could be slightly degraded. SXGA signal
				can be projected since the projector has simplified compatibility
				with them. (However, letters and lines can be inequal or a part
				can be missing. Some signals may not be projected at all.)
				• It is recommended to set an external monitor connected to the
				computer to XGA mode (1024 x 768).
				• The projector can be also applied to DDC2B (Display Data
				Channel 2B). If your computer is applied to the DDC, start up
				your computer after turning on the projector.

Operations

Continued