RECORDING
DSS® Satellite Receiver
The VCR can directly control channel selecting of the connected DSS® satellite receiver.
DSS® Satellite Receiver Control
This VCR needs to be connected to a DSS® satellite receiver equipped with an infrared wireless remote control. You can select satellite channels from the DSS® satellite receiver by operating this VCR.
DSS® is registered trademark of DIRECTV, Inc., a unit of GM Hughes Electronics.
It is also possible to automatically change the satellite channels according to your program setting in the timer program recording.
Placing the DSS® Satellite
Receiver
Put the DSS® satellite receiver on the top of the VCR as shown below. Do not block the sensor window.
DSS® satellite receiver
Wall
Sensor window | Front of the VCR |
|
The infrared signals come out of the sensor window and the front of the VCR. Then they bounce off walls and other objects in the room and are received by the DSS® satellite receiver. The VCR sends out infrared signals to your DSS® satellite receiver even during timer program recording.
Notes
•If the channels cannot be controlled properly because the infrared signal fails to reach the DSS® satellite receiver, change the position of the receiver on the VCR so that it can receive the signal.
•Keep the DSS® satellite receiver turned on even while the VCR is in the timer program recording.
Connection Type
Type A
Satellite antenna
| RF IN |
|
4CH | RF OUT | |
3CH |
|
|
DSS® satellite receiver | RF IN | |
|
|
| RF OUT |
Type B |
|
Satellite | Incoming cable |
antenna |
DSS® satellite receiver
3CH 4CH
LINE IN 1
LINE OUT
(Continued)
RECORDING
3 7