VCR Plus+ C3 ® system Recording (continued)

5

Press ENTER.

 

 

 

 

 

 

 

 

 

 

 

PROGRAM

 

 

SET UP

 

 

PRESET

 

 

 

The program setting is now memorized.

 

 

 

 

 

 

 

 

 

 

 

OFF SPD

 

 

 

CH DATE

 

On

 

 

 

25 8

/ 30 9

:30PM 10 : 0

0PM

SLP

 

 

• If your cable box is not remote-

 

–– –

/ ––

–

: ––

 

– : –

–

 

–

 

 

controllable, select the recording

 

–– – / –– – : –– – : –– –

 

 

–– – / ––

– : ––

 

– : ––

–

 

channel on the cable box beforehand.

 

–– – / –– – : –– – : –– –

 

 

–– – / ––

– : ––

 

– : ––

–

 

 

 

EnD: PROG

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

6

To set another program, repeat steps 1 to 5.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

7

To finish press the two TIMER

 

REC

 

 

 

 

 

 

 

 

TIMER

 

 

buttons simultaneously.

The VCR enters the timer standby mode.

POWER

TIMER

Confirming the VCR Plus+ C3 ® system timer programs

Before the VCR enters the timer standby mode (TIMER indicator not lit)

1)Press PROG. to display the MENU screen.

2)Press ENTER to select “PROGRAM”. Check the programmed data.

3)Press PROG. to exit.

During the timer standby mode (TIMER indicator lit)

Press PROG..

The screen for confirming appears.

After about 30 seconds, the screen disappears.

Canceling the VCR Plus+ C3 ® system timer programs

1)If the TIMER indicator is lit, press both TIMER to turn it off, and turn on the VCR by pressing

POWER.

2)Press PROG. to display the MENU screen.

3)Press ENTER to select “PROGRAM”.

4)Select a program which you want to cancel.

5)Press CANCEL.

The line is cleared out.

6)Press PROG. to exit.

Recording or playback in the timer standby mode

First press both TIMER to release the timer standby mode, and then press POWER to turn on the VCR. The VCR will be available for use.

•Be sure to press both TIMER again to return the VCR to the timer standby mode after you have finished.

Error indications

If “FULL / CANCEL PROG?” message appears on the TV during programming, no more programs can be entered. If you want to add another, delete one existing program on the screen by using PLAY/x2 or STOP.

If an incorrect PlusCode® programming number is entered, “ERROR CODE ENTERED” appears on the screen. Press CANCEL to clear the number and enter correct one.

If “CLASH” message appears on the TV during programming, it tells you that two programs with the same recording start time have been entered. Correct either of the two programs as follows:

1)Select the number of the program to correct by using PLAY/x2 or STOP.

2)Correct the data, or clear out the line by pressing CANCEL and then press

VCR Plus+ to enter a PlusCode® programming number.

3 2