ØSupports ACPI, PCI power management
ØComplies with the IEEE802.3u Fast Ethernet,
ØSupports Full Duplex Flow Control (IEEE 802.3x)
ØFull duplex design to double the performance
ØSupports
Ø
ØContains two large (2Kbyte) independent receive and transmit FIFOs
ØOne STP/UTP connector for 10Mbps or 100Mbps network Speed
ØProvides diagnostic software and one LED to indicate network Link/activity
ØSupports smart remote boot ROM and provides the help for RPL/PXE(Exclude
ØSupports ODI Driver for NetWare 3.x, 4.x, NDIS Driver for LAN Manager, Windows 95, Windows NT, Windows 2000, Packet driver forTCP/IP
Chapter 2 Installation
Card Installation
To insert The Product into your computer, follow the steps list below.
1 
Turn off the computer and remove its cover.
2 
Insert The Product into a PCI slot.
3 
Secure the Product to the rear of the computer chassis and put back the computer cover.
4 
Connect the Product to the network using
Driver Installation
Use the drivers supplied by the diskette included in The Product. For detail description, please refer to "help" in the diskette provided by the Product.
Appendix A: Troubleshooting
If you experience any problems with the adapter, first make sure the appropriate driver is loaded, the proper cable is connected to the adapter port and the hub complies with the adapter specification, such as 10Mbps
The Product provided one LEDs to indicate network status.
LINK/ACTIVE LED
A red LED indicates if the 10 or 100Mbps STP/UTP has been link OK or not and is working or not. When the light is OFF, it indicates that the STP/UTP port has not been connected or link not OK; When the light is ON, it indicates that the STP/UTP port link OK. When the light is BLINKING, it indicates that the STP/UTP port is receiving data or transmitting data.
Appendix B: Technical Specification
Topology: Star
Connector Supported: RJ45
Standard: IEEE802.3
Transmission Rate: 100Mbps or 200Mbps
Hardware: IBM PC compatibles(It must have PCI slot)
IRQ Line: Assigned by system
I/O Address: Assigned by system
Software: ODI driver for NetWare 3.x, 4.x, NDIS driver for Microsoft LAN manager and Windows 98, Windows ME, Windows NT, Windows 2000 Packet driver for TCP/IP
Temperature: 0o C to 40o C (Operating)
Humidity: 5% to 95%
Power consumption: 1W(Max)
Appendix C: Contact Information
For help with the installation or operation of the
Add: Fl.3,
Website:
Made in China
71030429
Ver: 2.0
User's Guide
TF-3239D/TF-3239DL
10/100M Fast Ethernet Adapter
3 | 4 | 5 | 2 |
