TP-Link tl-sg1048 manual Appearance, Front Panel, LEDs, For TL-SG1008PE

Gigabit Unmanaged Switch

•• Supports IEEE802.3x flow control for full-duplex mode and backpressure for half- duplex transfer mode

•• Non-blocking switching architecture that forwards and filters packets at full wire- speed for maximum throughput

•• Supports MAC address auto-learning and auto-aging

•• Desktop and rack-mountable steel case

•• Internal power supply

For TL-SG1008PE:

•• Complies with IEEE802.3, IEEE802.3u, IEEE802.3ab, IEEE802.3x, IEEE802.3af and IEEE802.3at standards

•• 8 10/100/1000Mbps Auto-Negotiation RJ45 ports all supporting PoE function and Auto-MDI/MDIX

•• Supports PoE power up to 124W for all PoE ports

•• Supports PoE IEEE802.3af/IEEE802.3at-compliant PDs

•• Supports IEEE802.3x flow control for Full-duplex Mode and backpressure for Half- duplex Mode

•• 8K entry MAC address table of the TL-SG1008PE with auto-learning and auto-aging

•• Internal power supply

1111 Appearance

■■ Front Panel

The front panel of TL-SG1048 is shown as the following figure.

LEDs

10/100/1000Mbps RJ45 Port

			FFFFFFFFFFF Front Panel of TL-SG1048
LEDs
LED	Status			Indication
Power	On			The switch is powered on.
	Off			The switch is powered off or power supply is abnormal.
	On	Green		A 1000Mbps device is connected to the corresponding port.
Link/Act		Yellow		A 10/100Mbps device is connected to the corresponding port.
	Flashing			The corresponding port is transmitting or receiving data.
	Off			There is no device linked to the corresponding port.

Introduction 02