TP-Link TL-SG2424 Rear Panel, Reset, LEDs, 10/100/1000Mbps RJ45 Port, SFP Port, Port Feature

Gigabit Smart Switch

Reset

Press this button for five seconds or above to reset the software setting back to factory default settings.

LEDs

LED		Status	Indication
Power		On	The Switch is powered on
		Off	The Switch is powered off or power supply is abnormal
		On	The Switch is working abnormally
System		Flashing	The Switch is working normally
		Off	The Switch is working abnormally
		On	There is a device linked to the corresponding port but no
			activity
Link/Act
		Flashing	The corresponding port is transmitting or receiving data
		Off	There is no device linked to the corresponding port
		On	A 1000Mbps device is connected to the corresponding
			port
1000Mbps
		Off	A 10/100Mbps device or no device is connected to the
			corresponding port
Port Feature
	Model			10/100/1000Mbps RJ45 Port	SFP Port
TL-SG2216				16	2
TL-SG2424				24	4

10/100/1000Mbps RJ45 Port

Designed to connect to the device with a bandwidth of 10Mbps, 100Mbps or 1000Mbps. Each has a corresponding Link/Act LED and a 1000Mbps LED.

SFP Port

Designed to install the SFP module. TL-SG2216/TL-SG2424 Switch features 2/4 SFP transceiver slots that are shared with the associated RJ45 ports. The associated two ports are referred as a “Combo” ports, which means they cannot be used simultaneously, otherwise only SFP port works.

Rear Panel

The rear panel of TL-SG2216 is shown as the following figure.

Grounding Terminal

Power Socket

FFFFFFFFFFF Rear Panel of TL-SG2216

02 Introduction