TP-Link TL-WN310G Chapter2.

54M Wireless Adapter User GuideTL-WN310G

- 2 -

Chapter2. Installation Guide

To install the adapter, follow these steps listed below:

1. Locate an available CardBus slot on your laptop.

2. With the connector pin end facing the CardBus slot and the label facing up, slide the Adapter

into the CardBus slot until it locks in place.

3. The Status LED should Intermittent flashing when the Adapter is installed correctly.

2.2.1 Overview

The Adapter’s Setup Wizard will guide you through the Installation procedure for Windows 2000,

XP. The Setup Wizard will install the TP-LINK Wireless Client Utility (TWCU) and drivers.

When you install the hardware before installing the software, the system will prompt “Found

New Hardware Wizard”, click Cancel, and run the Setup Wizard program on the CD-ROM.

The Setup steps for Windows 2000, XP are very similar. The following setup steps are for

Windows 2000.

2.2.2 Software Installation for Windows 2000

1. Insert the Resource CD into your CD-ROM drive, Click the Start button and choose Run. In

the field that appears, enter F:\XXX\Setup.exe (If "F" is the letter of your CD-ROM drive, XXX

represents the setup program path, which is labeled on the Resource CD), then Figure 2-1

will appear.

Figure 2-1