TP-Link TP-PA2010P 4.3 System

TL-PA2010P AV200 Powerline Adapter with AC Pass Through

17

4.3 System

The System tab window is for some basic settings of the adapter. On this tab window, you can upgrade

the firmware to the latest version, reset the adapter’s settings to the factory defaults and configure all

adapters’ network names.

4.3.1 Upgrade Firmware

Click the Upgrade Firmware button to upgrade the version of the firmware for the adapter and the

following dialog will pop up.

z NVM: None-volatile memory. It is used for upgrading the firmware.

z PIB: Parameter Information Block. It contains configuration values that establish device

network identity, general capabilities and operational modes.

Contents

Main COPYRIGHT & TRADEMARKS FCC STATEMENT CE Mark Warning Safety Information This product can be used in the following countries: TP-LINK TECHNOLOGIES CO., LTD DECLARATION OF CONFORMITY CONTENTS Package Contents Chapter 1 Introduction Appendix A: Troubleshooting Chapter 2 Connecting Mechanism Chapter 5 Advanced Feature: How to Use the Pair Buttons.............................. 19 Package Contents Chapter 1 Introduction 1.1 Conventions 1.2 System Requirement 1.3 Important Safety Instructions Page Chapter 2 Connecting Mechanism 2.1 Introduction 2.2 LED Indicator 2.3 Physical Interface 2.4 Connection Instruction 2.5 Hardware Connection Computer 2.6 Hardware Connection Internet Page Chapter 3 Installing Management Utility Page Page Page Chapter 4 Using the Management Utility 4.1 Status 4.2 Network Page Page 4.3 System Page Chapter 5 Advanced Feature: How to Use the Pair Buttons 5.1 Pair (Secure with 128 bits-AES) 5.2 Set Up a Powerline AV Network with the Pair Button Page Appendix A: Troubleshooting