Project | Quantity | Item # |
Model Specified: |
| CSI Section 11400 |
|
|
|
Specifications
Construction, Hardware and Insulation
Cabinet exterior front, one piece sides, louver assembly and doors are constructed of 20 gauge stainless steel with #4 finish. Cabinet interior and door liners are constructed of stainless steel. The exterior cabinet top, back and bottom are constructed of heavy gauge aluminized steel. A set of four (4) adjustable 6" high stainless steel legs are included.
Doors are equipped with a gasket protecting metal door pan, removable plug cylinder locks and guaranteed for life
Easily removable for cleaning, vinyl magnetic door gasket assures tight door seal. Anti condensate heaters are located behind each door opening.
Both the cabinet and door(s) are insulated with an average of 2" thick high density,
DIMENSIONAL DATA | RSL232NUT | RSL332NUT |
Net capacity cu. ft. | 46.0 (1303 cu l) | 69.5 (1969 cu l) |
Length - overall in. | 521⁄8 (132.4 cm) | 765⁄16 (193.8 cm) |
Depth - overall in. | 35 (88.8 cm) | 35 (88.8 cm) |
Depth - over body in. | 32 (81.3 cm) | 32 (81.3 cm) |
Depth - with door open | 553⁄4 (141.6 cm) | 553⁄4 (141.6 cm) |
90 degrees in. |
|
|
Clear door width in. | 211⁄8 (53.6 cm) | 211⁄8 (53.6 cm) |
Clear | 271⁄2 (69.9 cm) | 271⁄2 (69.9 cm) |
Clear | 575⁄8 (146.3 cm) | 575⁄8 (146.3 cm) |
Height - overall on 6" legs | 831⁄4 (211.5 cm) | 831⁄4 (211.5 cm) |
Shelf area sq. ft. | 34.6 (3.21 cu m) | 51.9 (4.82 cu m) |
Net Wt. lbs. | 700 (318 kg) | 995 (451 kg) |
ELECTRICAL DATA |
|
|
Voltage | ||
Feed wires with Ground | 4 | 4 |
Full load amperes | 10.2 | 18.4 |
REFRIGERATION DATA |
|
|
|
|
|
Refrigerant | ||
|
|
|
BTU/HR H.P.1 | 4130 (1 HP) | 2 x 5560 (3⁄4 HP) |
NOTES
NOTE: Figures in parentheses reflect metric equivalents. 1=Based on a 90 degree F ambient and
2=For approximate remote weights deduct 40 lbs. from respective net or gross weight. For other information on remote models, please refer to spec sheet
Refrigeration System
The
These freezer models contain mullion coolers with an auxiliary fan for increased air flow throughout the interior of the cabinet. This affords maximum heat transfer between the air and product, resulting in faster freezing.
Controller
The easy to use water resistant
Interior
Standard interior arrangements include three (3) chrome plated wire shelves per section, mounted on shelf pins. Shelves are
Warranties
Both a one year parts and labor warranty and a five year compressor warranty (self- contained models only) are provided standard. An optional 2nd year extended parts and labor warranty is also available. In addition the
Equipped With One NEMA
Full load amps and plug style may vary depending on electrical options
chosen and condensing unit employed.
NOTE: When ordering please specify: Voltage, Hinging, Door Size, Options and
any additional warranties. For fast order entry: Fax 1 (800)
Continued product development may necessitate specification changes without notice. Part No. TR35807 (revised 1/07)
REQUIRED CLEARANCES
In order to assure optimum performance, the condensing unit MUST have an adequate supply of air for cooling purposes. Therefore, the operating location must either have a minimum of 12” clearance overhead of the condensing unit or allow for unrestricted air flow at the back of the unit. Clearance of at least 12” above is required in order to perform certain maintenance tasks.
SECTION | TRAULSEN |
|
4401 BLUE MOUND RD. | FT. WORTH, TX 76106 | |
PHONE 1 (800) |
Website: www.traulsen.com