Something Not Working

Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without calling out an engineer. Before contacting your local Service Centre, please carry out the checks listed below.

IMPORTANT: if you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is under guarantee.

Symptom

 

Possible causes

 

 

 

The tumble dryer does not start

The door has not been closed.

 

The plug is not properly inserted in the power

 

 

socket.

 

There is no current at the socket

 

The main fuse or the fuse in the plug has blown.

 

A drying time has not been selected.

 

The water reservoir is full or not properly

 

 

inserted (the pilot light FULL TANK is on).

 

 

 

Drying takes too long or laundry is not

The laundry has not been spun properly.

dry enough.

The filter and/or air condenser are clogged up.

 

The water reservoir is full during operation.

 

The room temperature is too high.

 

The selected time or section was not suitable for

 

 

the laundry

 

There is too much laundry inside the appliance.

 

The dryer is not correctly installed.

If after the above checks, there is still a fault, call

Customer Care

your local Electrolux Service Force Centre.

For general enquiries concerning your Electrolux

 

Service & Spare Parts

appliance or for further information on Electrolux

products, please contact our Customer Care

If you require an engineer or wish to purchase spare

Department by letter or telephone as follows:

 

 

parts contact your local Electrolux Service Force

 

 

Centre by telephoning:

Customer Care Department

0870 5 929929

Electrolux

Your telephone call will be routed to the Service

55-57 High Street

Slough

Centre covering your post code area.

Berkshire

The addresses are detailed in this instruction book on

the pages headed Electrolux Service Force Centres,

SL1 1DZ

and can also be found in your local telephone

Tel 08705 950950*

 

directory under “E”.

When you call the Service Force Centre please make

sure you give the model and serial number of the

* calls to this number may be recorded for training

purposes.

appliance.

 

This information can be found on the rating plate

 

(see picture on page 4 ) or on the guarantee card.

 

In-guarantee customers should ensure that the

 

above checks have been made as the engineer will

 

make a charge if the fault is not a mechanical or

 

electrical breakdown. Please note that proof of

 

purchase is required for any in-guarantee service

 

calls.

 

10

Page 10
Image 10
Tricity Bendix BTD 01 installation instructions Something Not Working, Customer Care, Service & Spare Parts, 0870 5