Tricity Bendix FD 792 installation instructions Door reversal directions, Reversing door handles

Door reversal directions

Important

Before carrying out the operations described below unplug the mains lead from the wall socket.

To carry out this reversal, proceed as follows:

1.Gently lay the fridge-freezer on its back with the top held away from the floor by 5-8 cm (2-3 inches) of packing.

2.Using a PHILLIPS screwdriver remove the top hinge.

3.Slide out the upper door from the middle hinge.

4.Unscrew the left levelling foot.

Unscrew the right levelling foot, hinge and refit them on the left side.

Refit the other foot on the right side.

5.Slide out the lower door from the middle hinge.

6.Remove the middle hinge.

7.Remove the plastic plugs from the screw holes of the new top & middle hinge location and refit them in the holes on the opposite side.

8.Remove the screws from the new location of the bottom hinge and refit them in the free holes on the opposite side.

9.Refit the middle hinge as shown in Fig., i.e. up-side- down with respect to the previous position.

10.Replace the lower & upper door making sure that the pins of the middle hinge fit into the corresponding bushing on the door.

11.Replace the bottom hinge on the left side of the lower base of the cabinet (the fastening holes are already provided). Refit the top hinge.

Important

The central hinge is designed to allow a certain amount of side clearance (play), i.e. approx. 3 mm horizontally, which makes it easy to line up the two doors by proceeding as follows:

Loosen the two screws securing the hinge to the cabinet.

Carefully position the hinge until the two doors are perfectly aligned, then firmly screw down the hinge in its new setting (position).

Reversing door handles

Remove the handle by unscrewing the two fastening screws.

Remove the plastic plugs from the screw holes of the new handle location and refit them in the free holes onthe opposite side;

Refit the handle upside-down, on the opposite side of the door.

Attention

After completion of the door reversing operation, check that the door gasket adheres to the cabinet. If the ambient temperature is cold (i.e. in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fitting of the gasket or accelerate this process by heating up the part involved with a normal hairdrier.

Printed on recyclated paper

D185

PR132

D053

PR184

19