Overhanging surfaces or a cooker hood should be a minimum of 685mm above the hob.
It is important to ensure that the appliance is level after installation. Levelling feet are fitted to the appliance to accommodate uneven floors.
FITTING THE STABILITY BRACKET
It is recommended that a stability bracket supplied with the appliance be fitted during installation.
The instructions are as follows.
1.Place the appliance in its intended position and level appliance.
2.Mark off 280mm from the left hand side at the base of the appliance as shown in dimension 'A', Fig 1. This is the centre line of the fixing bracket.
3.Draw a line across the front edge of the feet (see Fig 1) and remove appliance from its position. Mark off dimension 'B' (see Fig 1) back from this line on the centre line of the bracket to locate the front edge of the lower bracket. Fix lower bracket (with two fixing holes) to the floor then measure the height from floor level to engagement edge on back of appliance, dimension 'C' of Fig. 2.
4.Assemble upper bracket to lower bracket so that underside of bracket is dimension 'C' +3mm above floor level. (see Fig. 2).
Reposition appliance and check that top bracket engages into appliance back, as shown in Fig. 2.
415mm(B)
(C)
(A)
280mm
Fig. 1 |
| Fig. 2 |
|
|
|
GENERAL NOTES ON USING YOUR APPLIANCE
We suggest that you run the oven elements for 10 – 15 minutes at 220oC to burn off any residue from their surfaces. The procedure should be repeated with the grill for approximately 5 – 10 minutes. During this period an odour may be emitted, it is therefore advisable to open a window for ventilation.
ABOUT CONDENSATION AND STEAM
When food is heated it produces steam similar to a boiling kettle. The oven is vented to allow some of this steam to escape. However, always stand back from the appliance when opening the oven door to allow any build up of steam or heat to release.
If the steam comes into contact with a cool surface on the outside of the appliance, e.g. a trim, it will condense and produce water droplets. This is quite normal and is not caused by a fault on the appliance.
To prevent discolouration, regularly wipe away condensation and also soilage from surfaces.
For your safety wall coverings at the rear of the appliance should be securely fixed to the wall.
OVEN / GRILL INDICATOR NEON
This light indicates whether the oven or the grill is switched on. The neon also indicates when the set temperature is being maintained. The neon will turn on and off during cooking. In the case of the oven the neon indicates when the correct temperature has been reached.
GRILL AND OVEN FURNITURE
The following items of grill/oven furniture have been supplied with the appliance.
1 grill pan
1 grill pan handle
1 grill pan grid
2 straight shelves for oven/grill cooking
9
