Tricity Bendix TBDW 32 manual Something not working

Something not working

IMPORTANT!

The dishwasher will not start or stops during operation.

Certain problems are due to the lack of simple maintenance or oversights, which can be solved with the help of the indications described in the chart, without calling out an engineer.

Open the door and see which fault code is active.

Switch off the dishwasher and carry out the following suggested corrective actions.

Fault code / malfunction	Possible cause	Solution
The dishwasher does not fill with	The water tap is blocked or furred	Clean the water tap.
	with limescale.
water.
	The water tap is turned off.	Turn the water tap on.
- continuous flashing of the
	The filter (where present) in the .	Clean the filter in the.
start/cancel indicator light
	threaded hose fitting at the water	threaded hose fitting.
- 1 intermittent audible signal	inlet valve is blocked.
- 1 flash of the "end of	The water inlet hose has not been	Check the water inlet hose
	correctly laid or it is bent or	connection.
programme" indicator light
	squashed.
The dishwasher will not drain.	The sink spigot is blocked.	Clean out the sink spigot.
- continuous flashing of the	The water drain hose has not been	Check the water drain hose
start/cancel indicator light
- 2 intermittent audible signals	correctly laid or it is bent or	connection.
	squashed.
- 2 flashes of the "end of
programme" indicator light
	The dishwasher door has not been	Close the door
	properly closed.
The programme does not start.	The main plug is not plugged in.	Insert the mains plug
	The fuse has blown in the household	Replace the fuse.
	fuse box.

Once these checks have been carried out; switch on the dishwasher, press the Programme/Cancel button and close the door. The programme will continue from the point at which it was interrupted. If the malfunction or fault code reappears contact the Service Force Centre.

For other combinations of fault codes not described in the above chart, please contact your Service Force Centre.

19