Unpacking
Warning !
Slide out the polythene bag containing the 
polystyrene block before using the appliance.
Pull off adhesive strips from inside machine on top of drum.
P1106 |
Should the appliance be moved, it must be transported vertically.
Positioning
It is recommended that, for your convenience, the machine is positioned close to your washing machine.
The tumble dryer must be installed in a clean place, where dirt does not build up.
Air must be able to circulate freely all round the appliance. Do not obstruct the front ventilation grille or the air intake grille at the back of the machine.
To keep vibration and noise to a minimum when the dryer is in use, it should be placed on a firm, level surface.
Once in its permanent operating position, check that the dryer is absolutely level with the aid of a spirit level. If it is not, raise or lower the feet until it is.
The feet must never be removed.
Do not restrict the floor clearance through deep- pile carpets, strips of wood or similar. This might cause heat
The appliance must not be installed behind the lockable door, a sliding door or a door
with a hinge on the opposite side to that of the appliance.
Important
The hot air emitted by the tumble dryer can reach temperatures of up to 60°C. The appliance must therefore not be installed on floors which are not
resistant to high temperatures.
When operating the tumble dryer, the room temperature must not be lower than +5°C and higher than +35°C, as it may affect the performance of the appliance.
Stacking kit (optional accessory)
It should be possible to stack your new dryer on top of a front loading washing machine with a worktop depth of between 48 and 60 cm.
The instructions are supplied with the kit.
Please contact your Local Service Force Centre for further advice.
P1148
Door reversal
To make it easier to load or unload the laundry the door can be reversed.
This operation must be carried out by qualified personnel.
Please contact the nearest Service Force Centre.
This will be a chargeable option.
Electrical connection
Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person.
WARNING: THIS APPLIANCE MUST BE EARTHED.
The manufacturer declines any responsibility for damage or injury through failure to comply with the above safety precautions.
Should the appliance power supply cable need to be replaced, this should be carried out by our Service Centre.
16
