Troy-Bilt 3090XP Assembly & Set-Up, Handle, Assembly, Contents of Carton, Chute Assembly (Model 2410)

Assembly & Set-Up	3
Contents of Carton

•	One Snow Thrower	•	Two Replacement Auger Shear Pins	•	One Chute Assembly (Model 2410)
•	One Snow Thrower Operator’s	•	One Product Registration Card	•	One Chute Control Rod
	Manual				(Models 2620, 2840 and 3090XP)

•One Engine Manual

AssemblyHandle

1.Place the shift lever in the Forward-6 position.

2. Observe the lower rear area of the snow thrower to be sure both cables are aligned with roller guides before pivoting the handle upward. See Fig. 3-1.

Figure 3-2

Chute Assembly (Model 2410)

1. Position the chute assembly over the base. See Fig. 3-3.

Figure 3-1

NOTE: Make certain the cables are seated properly in the roller guides. See Fig. 3-2.

3.Secure the handle by tightening the plastic knob located on both the left and right sides of the handle. Remove and discard any rubber bands, if present. They are for

packaging purposes only.

Figure 3-3

7