b.Slip plastic channel of grass bag over hooks on the frame. See Figure 3-7.

1.On the side of the mower, lift the side mulching plug. See Figure 3-9.

Side Mulching

Plug

1

2

Figure 3-7

2.Follow steps below to attach grass catcher:

a.Lift rear discharge door.

b.Place grass catcher into the slots in the handle brackets as shown in Figure 3-8. Let go of discharge door so that it rests on the grass catcher.

A

B

B

Figure 3-8

To remove grass catcher, lift rear discharge door on the mower. Lift grass catcher up and off of the slots in the handle brackets. Release rear discharge door to allow it to close rear opening of mower.

Side Discharge Chute

Your mower is shipped as a mulcher. To convert to side discharge, make sure grass catcher is off of the unit and rear discharge door is closed.

Figure 3-9

2.Slide two hooks of side discharge chute under hinge pin on mulching plug assembly. Lower the mulching plug. Do not remove side mulching plug at any time, even when you are not mulching.

Adjustments

Cutting Height

The cutting height adjustment lever is located above the rear left wheel.

1.Depress height adjustment lever towards wheel.

2.Slide lever to desired position for a change in cutting height. Refer to Figure 3-10 for low wheel adjustment and Figure 3-11 for high wheel.

2 Lower

Higher

3

1

Low Wheel

Figure 3-10

Section 3 — Assembly & Set-Up

 

11