2.Align the holes in the chute base with the holes in the lower chute and secure with the previously removed hex washer screws. See Fig. 3-4.

Figure 3-4

Installing the Chute Rotation Control (If so equipped)

To install the chute rotation control (only models so equipped) proceed as follows:

1.Remove the hex lock nut and machine screw from the chute rotation control. See Fig. 3-5.

1

Chute Rotation Control

Hex Lock

 

Nut

Machine Screw

2

 

 

 

 

Hex Lock

 

 

Nut

Chute Control Rod

Machine Screw

Figure 3-5

2.Place the chute rotation control onto the chute rotation rod and secure with the hex lock nut and machine screw removed in step 1. See Fig. 3-5.

Installing the Drift Cutters (If so equipped)

1.Remove the carriage bolts and flange lock nuts from the drift cutters.

2.Install the drift cutters and secure with the carriage bolts and flange lock nuts removed in step 1. See Fig. 3-6.

Drift Cutter

Flange Lock Nut

Carriage Bolt

Figure 3-6

Installing the Recoil Starter Handle

1.Remove the eye bolt and handle knob from the manual bag.

2.Place the eye bolt and handle knob on the upper handle as shown in Fig. 3-7. Do not fully tighten the hardware until instructed to do so.

Eye Bolt

Recoil Starter

Handle

A Handle

Knob

B

Figure 3-7

NOTE: The opening of the eye bolt should face toward the back of the snow thrower.

8Section 3— Assembly & Set-Up