Troy-Bilt T-106 Operation, To Convert Your Mower From A Mulcher To A Side Discharge Mower

Models: T-106

1 14
Download 14 pages 42.95 Kb
Page 9
Image 9
TO CONVERT YOUR MOWER FROM A MULCHER TO A SIDE DISCHARGE MOWER

TO CONVERT YOUR MOWER FROM A MULCHER TO A SIDE DISCHARGE MOWER

Lift mulching plug. Slide the two hooks on the side discharge deflector under the hinge pin on the mulching plug assembly. See fig- ure 6. Lower the mulching plug.

Mulching Plug

OPERATIONBEFORE STARTINGTO START ENGINE AND ENGAGE BLADETO STOP ENGINESide

USING YOUR MULCHER (Optional)Manual backgroundManual backgroundChute

Figure 6

OPERATION

BEFORE STARTING

Service the engine with gasoline and oil as instructed in the separate engine manual packed in your mower. Read instructions carefully.

WARNING: Never fill fuel tank in- doors, with engine running or until the engine has been allowed to cool for at least two minutes after run- ning.

TO START ENGINE AND ENGAGE BLADE

Attach spark plug wire to spark plug. If unit is equipped with a rubber boot over the end of the spark plug wire, make certain the metal loop on the end of the spark plug wire (inside the rubber boot) is fastened securely over the metal tip on the spark plug. See fig- ure 7.

Metal

 

Loop

 

on Spark

Rubber Boot

 

Figure 7

If your unit is equipped with a primer, prime engine as instructed in the separate engine manual packed with your unit.

If your unit is equipped with a throttle con- trol, move throttle lever to the FAST position as instructed in the separate engine manual packed with your unit.

Blade Control

Handle

Starter

Handle

Figure 8

Standing behind the unit, depress the blade control handle and hold it against the upper handle as shown in Figure 8.

Grasp the recoil starter handle as shown and pull up rapidly. Return it slowly to the rope guide bolt.

After engine starts, move throttle control to desired speed (if so equipped). The mower is designed to operate at FULL throttle while mowing.

WARNING: THIS CONTROL MECH- ANISM IS A SAFETY DEVICE. NEVER ATTEMPT TO BYPASS ITS OPERATIONS.

NOTE: The blade control handle must be depressed in order to operate the unit. Release the blade control handle to stop the engine and blade.

TO STOP ENGINE

Release the blade control handle to stop the engine and blade.

WARNING: The blade continues to rotate for a few seconds after the engine is shut off.

Disconnect and ground the spark plug wire as instructed in the separate engine manual to prevent accidental starting while equip- ment is unattended.

USING YOUR MULCHER (Optional)

WARNING: If you strike a foreign ob- ject, stop the engine. Remove wire from spark plug, thoroughly inspect the mower for any damage, and re- pair the damage before restarting and operating the mower. Extensive vibra- tion of the mower during operation is an indication of damage. The unit should be promptly inspected and repaired.

9

Page 9
Image 9
Troy-Bilt T-106 Operation, To Convert Your Mower From A Mulcher To A Side Discharge Mower, Before Starting, To Stop Engine