ASSEMBLY INSTRUCTIONS

For TB475SS only: ADJUST THE D-HANDLE

The TB475SS uses a D-handle only, which is pre- installed on the unit. If you ever need to adjust it, make sure it is at least 6 inches from the end of the shaft grip (Fig. 1).

Shaft

Housing

Shaft Grip

Minimum 6 inches

(15.24 cm)

Bottom Clamp

Fig. 1

For TB425CS only: INSTALL AND ADJUST THE J-HANDLE

1.Place the J-handle between the top and middle clamp pieces (Fig. 2).

(4) Screws

Top Clamp

J-Handle

Middle Clamp

 

Bottom Clamp

Nuts

 

 

Fig. 2

2.While holding the three pieces together, install the four

(4) screws through the top clamp and into middle clamp.

NOTE: The holes in the top and middle clamp will line up only when assembled correctly.

3.Place the clamps and the J-handle over the shaft housing and onto the bottom clamp.

4.Hold each hex nut in the bottom clamp recess with a finger. Start screws with a large Phillips screwdriver. Do not tighten until you make the handle adjustment.

5.Slide the J-handle in or out until the arrow/white line on the decal touches the clamp assembly (Fig. 3). You must first loosen the screws if the handle is pre-installed.

Decal

Fig. 3

6.While holding the unit in the operating position (Fig. 27), position the J-handle to the location that provides you the best grip.

7.Tighten the clamp screws evenly, until the J-handle is secure.

7