OPERATING INSTRUCTIONS
OPERATING THE EZ-LINK™ SYSTEM

The EZ-Link™ system enables the use of these optional Add-Ons:

Cultivator . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . TBGC

Edger . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . TBLE

Hedge Trimmer . . . . . . . . . . . . . . . . . . . . . . . . . . . TBAH

Straight Shaft Trimmer . . . . . . . . . . . . . . . . . . . . . . TBSS

Turbo Blower . . . . . . . . . . . . . . . . . . . . . . . . . . . . . TBTB

Pole Saw . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . TBPS

WARNING: Prior to operation, read and understand

the operator’s manual for unit to be used with this add-on.

Removing the Cutting Attachment or Add-Ons

1.Turn the knob counterclockwise to loosen (Fig. 9).

2.Press and hold the release button (Fig. 9).

3.While firmly holding the upper shaft housing, pull the cutting attachment or add-on straight out of the EZ-Link™ coupler (Fig. 10).

WARNING: To avoid serious personal injury and

damage to the unit, shut the unit off before removing or installing add-ons.

Installing the Cutting Attachment or Add-Ons

NOTE: To make installing or removing the add-on easier, place the unit on the ground or on a work bench.

1. Turn knob counterclockwise to loosen (Fig. 9).

EZ-Link™ Coupler

Release Button

 

Knob

Guide Recess

Fig. 9

2.While firmly holding the add-on, push it straight into the EZ-Link™ coupler (Fig. 10).

NOTE: Aligning the release button with the guide recess will help installation (Fig. 9).

Release Button

EZ-Link™ Coupler

Primary Hole

Upper Shaft Housing

Lower Shaft Housing

Fig. 10

3. Turn the knob clockwise to tighten (Fig. 11).

CAUTION: Lock the release button in the primary

hole (Fig. 10) and securely tighten the knob before operating this unit.

90˚ Edge

Trimming Hole

180˚ Trimming Hole/

Primary Hole

Knob

Fig. 11

CAUTION: The add-ons with the coupler system is to

be used in the primary hole only. Using the wrong hole could lead to personal injury or damage to the unit.

For decorative trimming/edging with the line head cutting attachment, lock the release button of the cutting attachment into the 90° hole or the 180° hole (Fig. 11).

For edging with the edger add-on, lock the release button of the cutting attachment only into the 180° trimming hole/ primary hole (Fig. 11).

10